- ページ 7

音楽ミキサー Ashly MX-406のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Ashly MX-406 12 ページ。 Stereo microphone/line mixer
Ashly MX-406 にも：取扱説明書 (12 ページ), テクニカルノートと仕様 (2 ページ), 取扱説明書 (12 ページ), 取扱説明書 (16 ページ)

ページを印刷する

6.2 Input Pad

The input pad is a 20dB attenuation switch on the rear

panel for use with the XLR microphone inputs . It should nor-

mally be left in the "out" position for best signal to noise ratio

and should only be used when the input is being overdriven

with the gain control at its minimum setting .

6.3 Line Input

The line input is a standard 1/4" TRS active balanced

type found in the same "combo jack" connector as the mic

input . The line input balanced impedance is 20KΩ . It will

accommodate a wide range of input levels .

6.4 Channel TRS Insert

A channel TRS insert patch point allows a device

such as a remote level controller, graphic equalizer, noise

gate, compressor/limiter, or direct out recording device to be

used with one or more input channels .

The MX-406 TRS insert jacks use the tip for output

and ring for the returning input . These signals will be unbal-

anced, so cable length should be at a minimum to maintain

low noise .

To use the TRS insert as a Direct Line Output (pre

EQ) for recording, you must make a special cable with tip and

ring connected at the MX-406 end and a tip-sleeve mono plug

at the other end. Connecting tip and ring at the mixer insert

jack is necessary for uninterrupted signal within the mixer

when using direct line outputs .

Operating Manual - MX-406 Stereo Microphone/Line Mixer

6.5 Stereo Line Input

line in 3 .5mm jack, have a nominal operating level of -10dBu to

match most consumer audio sources . This signal is controlled

by the Stereo Line Input dial on the front panel . This input is

also used as a stereo effects return, or as a stacking input for

adding additional mixers .

6.6 Stereo Line Out

master", so they are not affected by the settings of the main

Left/Right output controls . These outputs would be used for

making a pre-output fader recording off of the stereo mix, or

for stacking the MX-406 stereo output into another mixer .

6.7 Aux Master Output

monitor or zone amplifier, effects processor, recording device,

or any function which requires level control independent from

the main stereo mix . It is pseudo-balanced, which means that

while it is a single ended signal, it has balanced impedance

for low noise when driving an active balanced input circuit

over a long distance .

6.8 Mono Output

stereo signals (pre output fader), and uses an isolation trans-

former capable of driving 600 ohm lines . Pin 1 is ground, pin

2 is (+), and pin 3 is (-) . This signal is determined by the mono

output level control, with a nominal operating level of +4dBu .

The stereo line RCA inputs, and the front panel stereo

The stereo line outputs are nominal -10dBu "pre-

The 1/4" jack aux master output is used to drive a

The XLR mono output combines the left and right