- ページ 7

レシーバー Cypress COH-Rx1のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Cypress COH-Rx1 12 ページ。 Hdmi to optical transmitter and receiver

7. Operation Controls and Functions

Front Panel

HDMI

Error

Input

Optical

HDMI

① ③ ②

① Optical LED: This LED will illuminate in blue when at least one optical cable

is connected and has successfully detected and communicated

between Tx & Rx with video or audio data sending. If the LED is not

illuminate users need to check the connection of the fiber cable and

then make sure the connection is well and the cable itself is good.

② Error LED: This LED will not illuminate under a normal status. When it

illuminate in red, it means the HDMI input source is sending a data rate

that is higher then 75/170MHz (Single/Dual).

Check the connections and make sure they are all connected well.

③ HDMI LED: This LED will illuminate in blue, when the device is communicate

with the source.

④ HDMI Input: This slot is to connect with input source equipment such as

DVD/Blu-ray player with HDMI cable.

⑤ IR-Out: This slot is to connect with the IR blaster included in the package

for IR signal sending from the display side to the source equipment and

control it.

⑥ RS-232: This slot is to connect with 3.5Ø phone jack to D-Sub 9pin

converter adaptor included in the package for RS-232 control and signal

sending.

⑦ Optical SUB & Main: These slots are to connect with the optical 2 ways

cable from the transmitter side up to 300 meters.

Note: Connector Type: LC-LC, Fiber: Duplex Single-mode Fiber

⑧ DC 5V: This slot is to connect with the power adaptor included in the

package from the AC wall outlet for power supply.

IR-Out RS-232

④

⑤

⑥

Rear Panel

Optical

SUB

DC 5V

Main

⑦

⑧