- ページ 6

ドライヤー Dolphin BC 2012のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dolphin BC 2012 12 ページ。 Automatic velocity hand dryer

Fit terminal block cover to rear of dryer

Using the 2 screws provided.

Enure that the cable clamp has been fitted and

that the cover is flat against the rear of the

dryer.

Fixing the unit to the wall.

Hang the unit on the wall using the mounting

bracket provided. The 2 hooks on the rear of the

unit should locate inside the 2 slots on the wall

mounted bracket.

Install the 2 safety screws through the bottom of

the unit .

These screws MUST be fitted to stop the dryer

being taken/knocked off the wall.

Re-fit the air filter.

Line up the air filter so the 2 pins are at the top

as shown.

Once in close the air inlet door to retain the filter.

Re-fit the drain tank.

Making sure the lid is on. Push the drain tank

Into the dryer as shown.

Hand Dryer test run.

1. Check the voltage of the power supply.

Please use the stated rated voltage.

2. Turn on the RCD/power supply.

3. Remove drain tank (to gain access to power switch).

4. Turn on the power switch. The lamp should light up.

5. Select heat and speed setting required.

6. Close power switch cover, and replace drain tank.

7. Dry hands. (See page 7)

8. Check the unit. Is the unit firmly fitted to the wall? Is their any vibration or strange

noises?

*Do not turn the power switch on with your hands inside.

BC 2012 User Manual