録音機器 1010music Toolbox v2.0のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。1010music Toolbox v2.0 2 ページ。

Toolbox v2.0 Quick Start Guide

Toolbox is a sequencing workhorse that allows you to configure up to 64 event

sequencers and CV generators that will drive your samplers, synthesizers and

other sound making equipment. Song mode allows you to sequence the event

sequencers into Song sections to further automate playback and free you up

for more creative work. Presets save your work and allow you to quickly switch

sequence banks for different songs. Toolbox's intuitive touch screen and

knobs make it easy to configure all of this.

This quick start guide assumes a basic knowledge of Eurorack and provides a

high-level feature walk through. For more detailed information, download the

full user manual at 1010music.com.

Setup

To get started with toolbox, power down your Eurorack and connect the

ribbon cable to the toolbox and to a +12V power source in your rack. The

toolbox power connector is keyed and will only fit one way. On the rack side, the cable should be connected with the red stripe

nearest to the -12V pins. Mount toolbox to the rails using your preferred screws. Make sure the microSD card is in the memory card

slot and power up your rack. Connect the MIDI or CV outputs to other gear so you can hear the results of your work.

Overview

The toolbox functionality is organized into 4 primary screens. The first screen you see is the Main screen with its grid of up to 16 cells.

These cells host event sequencers and CV generators. Each cell is mapped to the corresponding output jack in the grid below the

touch screen. Touch the Keys button at the bottom of the screen to use an on-screen keyboard to record a sequence into the selected

event sequencer cell, identified at the top of the screen. On the Song screen you can enable song mode where you can record and

play back a series of activations and layer changes for the event sequencers. Note that the CV generators are always active, but they

can be muted. Finally, the Pset screen allows you to store all of your work into a preset and create new presets to capture your next

inspiration. You can push the HOME button at any time to go back to the Main screen. The INFO button will cycle through

configuration screens for the selected element on the screen. You can select cells by turning the top two knobs or touching the screen.

Toolbox has two operational modes: Normal mode and Song mode. The on-screen Song buttons turn blue when song mode is

enabled. In this mode, toolbox will play and record event sequencer activations and layer selections into the currently selected Song

section. It will also play any active sequences. You can change the active state of a sequence while a song section is playing in order to

improvise over the recording. When in Normal mode, you will play and record into event sequencers or CV generators.

Event Sequencers and CV Generators

On the first Info screen for each cell you can assign a cell mode by touching the cell mode name at the top of the screen, just to the

right of the grid icon. Touch the name of the mode in the list to select it. The cell modes allowed depend on the type of output jack

the cell corresponds to. There are two categories of cell modes: event sequencers and CV generators:

Cell mode

Cell Modes