- ページ 3

キーパッド Dolphin DOLGDO300310のPDF 使用方法をオンラインで閲覧またはダウンロードできます。Dolphin DOLGDO300310 4 ページ。 Wireless garage door keypad dual frequency 300/310 mhz

TIP: When you enter the correct code followed by #, the keypad LEDs flash slowly

for 5 seconds. If you enter an incorrect code, the keypad LED will glow steady for

5 seconds.

Figure 4

c. To change the 4 digit PIN (example)

TIP: When you have entered the programming mode of # # the small LED glows

a steady red. When you complete the change of the PIN the small LED flashes

twice quickly.

To reset the keypad to the factory default code, remove the 9 volt battery and

depress and hold any key on the keypad, then reinstall the battery. Continue holding

the key down for 5 seconds and then release the key. The keypad is now reset to

the factory defaults.

Position the keypad on the garage door frame with the provided screws.

Lift up the cover and insert the long screw above the keypad in the slot

provided (a).

Remove the battery cover and insert the second long screw in the

lower slot (b).

Replace the battery cover.

5. RETURN TO DEFAULT SETTINGS

Return to Default Settings

1. Desconnect the power by removing the battery.

2. Press the

3. Re-connect the battery to power up the keypad.

4. Release the

Note: The keypad is returned to the defaul "Master Code"

Entry Codes are deleted.

1-2-3-4

(Old Pin)

followed within 5 seconds by

, and

keys simultaneously.

, and

keys.

Back

Opening

dip

switches

_-_-_-_

(New PIN)

pin must be four digits

cover

. And all User