- ページ 4
バッテリーチャージャー Dolphin pro HD+ 24V40AのPDF テクニカル・マニュアルをオンラインで閲覧またはダウンロードできます。Dolphin pro HD+ 24V40A 16 ページ。
ページを印刷するSAFETY PRECAUTIONS
NOT-DOLPROHD-00
Maintenance precautions
In order to prevent any risk of electric
shock during maintenance work, the
following recommendations should be
strictly observed before carrying out any
work:
4Maintenance work should only be
carried out by an appropriately qualified
technician.
4To avoid danger, damaged mains
power and/or battery cables should only
be replaced by a qualified person.
4Mains power must be disconnected
(cable or on/off switch).
4 The -DC or -BAT battery side connection
must also be disconnected to avoid any
energy transfer.
4Wait 5 minutes for the high voltage
capacitors
to
electronics board), before working inside
the case.
4Fuses should be replaced by fuses of
identical rating and performance.
discharge
(on
INSTALLATION
NOT-DOLPROHD-00
WHEN YOU RECEIVE THE CHARGER
Package contents
Preliminary checks
the
charger rating, etc.).
Installation conditions
The charger is mounted using 4 screws, dia.
4mm (not supplied), on a support or wall that is
sufficiently strong.
Check that the mounting screws used are
compatible with the type of mounting wall (resin,
wood, metal, etc.).
The charger should be positioned against the wall
and mounted firmly. Ideally, the charger should
be mounted vertically, with the cable exit facing
downwards. Leave a free space of at least 10 cm
all around the case, to allow optimum convection,
particularly on the cooling air inlet/outlet sides.
Inside the charger, the cooling air flows from right
to left when viewed from the front (see photo
below).
4Charger.
4Installation manual.
4Mains power cable grommet with
its mounting nut (to be installed on
the case before connecting the
cables).
4Battery temperature sensor.
Check the charger identification
label, bonded on one of the case
sides, to ensure that the technical
data specified corresponds to your
requirement (mains power voltage,
EN