- ページ 6

照明器具 CyronMotor ABS1LHCのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CyronMotor ABS1LHC 8 ページ。 Auxiliary light

Figure 3

NOTE: For low beam applications the goal is to keep the light on the road as far

forward as possible without disturbing the oncoming traffic.

Secure the wires with zip ties. If mounted to lower forks or other moving parts avoid

leaving too much slack in the wires which could fray or get caught to other objects.

Leave just enough to clear the max extension of the moving parts.

Tighten all the screws. Thread-lock liquid has been provided to prevent screws from

coming loose overtime.

HINT: Check the alignment of the light again after a few hours on the road. To

facilitate mark the position of the light beam on garage wall after the initial alignment.

Compare at a later point to make sure the lights have remained aligned.

OPERATION:

Basic Power Cable:

Operation of the lights are based on your connection methods you have chosen. If lights

are connected using basic power cable as shown in Figure1 then lights can be turned on

with the appropriate switch per controlling options A, B or C.

Multifunction Cable:

Low beam aux light turns on when ignition is on. Hi beam aux light (ABS1H) turns on with

headlight hi beam switch. Low beam can be switched from yellow to white light by turning

the high beam light on and off in three flash speeds FAST-FAST-SLOW sequence.

Note: High beam must be off before starting the three flashes of on/off. See Figure 5.