- ページ 14
ステレオシステム Cyrus CD iのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cyrus CD i 18 ページ。 Hi-fi
Cyrus CD i にも： ユーザーマニュアル (15 ページ)
ページを印刷するCyrus CD i
Learning TV and Satellite commands
In addition to controlling Cyrus components, the remote
control can learn the commands from two other remote
control handsets. These will normally be a TV and a Satellite
or terrestrial TV set-top box, programmed to the TV and
SAT buttons, but could also be other audio components
including a cyrus tuner or dVd player etc.
All keys may be programmed with the exception of the
groups marked CONTROL and SOURCE and the SETUP key.
Preparation for learning:
Check the following points before attempting to learn any
commands -
•
Check that both remote controls have fresh batteries.
•
Choose a location on a tabletop that is not brightly lit.
Subdued light is better, away from bright natural or
indoor lighting.
•
Check that you have enough time to spare to complete
the learning process for all the keys you want to use.
Learning commands:
In this example, the Cyrus remote control will be learning
commands from a 'reference' Satellite receiver remote
control.
1.
Set the two remote controls up facing each other, spaced
by about 5cm.
2.
Press the TV or
SAT key to select
the mode that you
want to program.
The keypad will light and the key you selected will be red.
5cm
CONTROL
TV
SAT
SOURCE
ENTER
SELECT
TEXT
MENU
3.
Press and hold the
SETUP key.
The mode key will change to white. After about three
seconds, the mode key will light red again. This indicates
that the remote control is ready to learn codes.
4.
Release the SETUP key.
The remote control is now waiting to learn commands. The
keypad will light continually and the mode key will light pale
red.
5.
On the reference remote control, press and hold the first
key you want to learn (for example, volume up) until the
mode key flashes red.
This indicates that the command has been received.
6.
Release the key on the reference remote control.
7.
Press a key on the Cyrus remote control (volume up
in this example) to select where you want to save that
command.
The mode key will stop flashing. This indicates that the
command has been saved successfully.
If the learning process was successful, the remote control
will be ready to learn the next command.
8.
Repeat steps 5 to 7 for each command you want to
learn.
When you have completed learning all commands -
•
Press the SETUP key.
The mode key will change to white. After a few seconds the
backlight will switch off.
CH
12
User Instructions
1
2
3
abc
def
4
5
6
ghi
jkl
mno
7
8
9
tuv
wxyz
pqrs
0/10
STORE
TV/AV
SETUP
LIST