スピーカー Cyrus CLS70のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cyrus CLS70 4 ページ。
ページを印刷する
User Instructions
IMPORTANT CAUTIONS!
Read before installing this equipment!
•
Do not expose your loudspeakers to excessive cold, heat, humidity
or sunlight - see Maintenance.
•
Do not discard the original packaging. The original Cyrus packaging
is an important element of your warranty.
•
Do not connect your loudspeakers to the mains electricity supply.
•
Ensure that your loudspeakers are correctly wired and are in phase -
see 'Connecting your loudspeakers'.
•
Do not mount your loudspeakers by the rear panel. Wall brackets
must support the underside of the product.
When setting up the system or playing music it is always important to pay
particular attention to the following points-
•
Do not change any component in your system without first switching
off your amplifier. Every time you change the connections from any
signal source to your amplifier, ensure that you first switch off the
amplifier.
•
Do not use your amplifier at full power. This will 'clip' the amplifier
and may damage your loudspeakers. Full power with many
amplifiers can occur at around half volume setting.
•
When switching on your system, do so with the volume control at
minimum and turn the level up gradually.
•
When changing discs, adjusting tuners, rewinding tapes, etc., turn
the volume control down to its minimum.
•
Filters, tone controls or graphic equalisers are not recommended for
use in a system with CLS70 speakers.
•
Bolts for M5 sockets are inserted in the bottom panel of the CLS70
cabinet to allow proper connection to the dedicated Tripod stand.
Protective rubber feet are provided for bookshelf mounting. (3 feet
for each cabinet for optimum stability, 2 at the front and 1 at the
rear).
•
Never use CLS70's part supported on a shelf. All 3 feet must be
supported.
•
It is recommended that CLS70's should be attached securely to
stable loudspeaker stands. This will help performance as well as
stability.
Product Service
Should your loudspeakers fail please return them as a pair, even if only
one unit appears to be faulty. You must pack them using the original
packing to be eligible for any warranty claim. Replacement packaging is
available from the Cyrus service department.
Product for service should be returned in the first instance to the
appointed dealer from whom you purchased the product. If you
experience difficulties or there is no Cyrus dealer in your area, contact the
Cyrus distributor for your country.
GB
GB
Cyrus CLS70
1