- ページ 6
ツール BluePoint Fasteners BP-27CのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。BluePoint Fasteners BP-27C 13 ページ。
ページを印刷するINSTRUCTIONS CAN RESULT IN INJURY TO
THE TOOL OPERATOR OR BYSTANDERS
BP-27C IS NOT A STAND-ALONE TOOL.
IT MUST ALWAYS BE USED MOUNTED ON A BLUE POINT POLE.
FASTENER DRIVING SAFETY
1.
Use this tool ONLY to fasten into a
recommended base material.
2.
DO NOT fire the tool without a
fastener. If the tool is fired without
a fastener, the piston can hit the
work surface causing serious injury
to you and bystanders.
3.
Always use Spall Guard protection
whenever possible to minimize the
flying particles or debris.
4.
Always use the tool firmly and
perpendicular
to
the
work
surface and keep your hand
flexed before firing. Otherwise
the
fastener
may
ricochet
causing injury.
FAILURE TO FOLLOW THESE
5.
Never drive a fastener close to
the edge of the base material
or close to another fastener.
See installation page.
MISFIRE PROCEDURE
ALWAYS FOLLOW THE
MISFIRE PROCEDURE.
If the tool does not fire, continue to
hold the tool against the work surface
for at least 30 seconds. Then carefully
open the tool, remove the load and put
it in a can of water or other non-
flammable liquid. Never discard the
load into a dumpster.
If the tool becomes stuck or jammed
with a powder charge, point the tool in
a
safe
direction
and
label
immediately with "DANGER – DO NOT
USE – DEFECTIVE". Lock the tool in a box
and contact your local dealer for
assistance from BLUEPOINT.
10
APPLICATIONS OF FASTENERS
BP-27C tool can be used for a wide
range of fastening applications on a
variety of substrate materials.
For best results, read and follow these
important instructions for fastening.
These guidelines will help you perform
the fastening operation most effectively
and safely. Powder actuated fastenings
are permanent solutions. Any attempt
to remove them may cause serious
injury.
Fastening on Concrete
For fastening in concrete, keep a
minimum distance of 3" between
fastenings and 3" of any free edge.
Concrete thickness should be at least
three times the expected depth of
penetration into concrete. The drive
pin's ideal penetration is 1".
Fastening wood to concrete.
Concrete Fasteners driven too close to
an edge or too close together can cause
the concrete edge to fail or transfer to
fly free.
Penetration of thin gauge metal.
it
Fastening to Concrete Block or
Masonry Walls
This application is not recommended,
but if at all used, keep at least 3" edge
distance to avoid cracking the block and
excess penetration of fastener to avoid a
loss in holding value. Fastening is not
recommended for vertical joint.
Fastening to Steel
BP-27C tool can be used for fastening on
the flat surfaces of structural steel. For
steel fastening, always maintain a
minimum
of
1-1/2"
between
fasteners and 1/2" from any edge.
11
the