- ページ 11
ツール BluePoint Fasteners BP-302AのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。BluePoint Fasteners BP-302A 13 ページ。
ページを印刷するTROUBLESHOOTING
FAULT
CAUSE
•
Reduction or
Piston not being
loss of power
returned to the full
rear position
•
Worn or damaged
piston ring
•
Worn or broken
pawl
•
Tool does not
The firing pin
fire
and/or chamber
damaged
•
Tool is not being
fully depressed
•
Excessive dirt
build-up on
chamber face
•
Tool does not
Tool was
fully depress
assembled
incorrectly
•
Damaged parts
•
Debris jamming the
barrel or piston
assembly
•
Excessive
Power level too
fastener
high
•
penetration
Base material too
soft
•
Failure to index
Strip is damaged or
strip
not inserted in tool
properly
•
Indexing
mechanism
damaged
•
Tool cannot be
Damaged or bent
cocked or
piston
•
opened easily
Excessive dirt
build-up
•
Broken or damaged
parts
•
Failure of tool to
Retaining ball
stay closed when
missing
pointed in the
downward
position
POSSIBLE REMEDIES
•
Barrel must be pulled
completely open to
properly position the
piston
•
Replace worn or damaged
piston
•
Replace pawl
•
Replace the damaged part
•
See "Tool does not fully
depress"
•
After allowing misfire
procedure, check firing
pin indentation on load.
Clean chamber face.
•
Check all parts in the
receiver for damage or
improper assembly
•
Contact your distributor or
call the offices of Blue
Point Fasteners
•
Disassemble and remove
debris
•
Use a lower charge level.
•
Check the base material
and make sure it's not too
weak
•
Check load strip. If
damaged, dispose it off
appropriately
•
Contact Blue Point for
assistance.
•
Replace piston
•
Clean tool properly
•
Tag tool with warning :
"Defective-Do Not Use".
Place in a locked box and
contact your Blue Point
representative for service
•
Contact Blue Point for
assistance
20
TROUBLESHOOTING
FAULT
CAUSE
•
Piston Stuck in
Piston overdriven
down position
and stuck in muzzle
bushing
•
Load strip gets
Load stuck in the
stuck
chamber
•
Pin(s) stuck in
Pin inserted too far
fastener guide
POSSIBLE REMEDIES
•
Wear eye protection. Make
sure tool is unloaded, tap
on hard surface or drive
piston back with a lead or
brass hammer
•
Never try to remove an
unfired, live load from the
chamber. Call Blue Point
for assistance
•
Unscrew fastener guide,
remove buffer and push
the pin out with a
screwdriver
21