- ページ 5

電動工具 BluePoint Fasteners BP-361のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。BluePoint Fasteners BP-361 18 ページ。

ページを印刷する
INTRODUCTION
BP361 is a semi-automatic feeding low velocity powder-actuated fastening
tool. Continuous feeding of powder loads and pins for a wide range of
applications, make the BP361 tool a versatile, portable, safe and reliable tool.
PREPARATION
Suitable Base Materials:
Only the following materials are suitable
for Powder-actuated fastening:
•
Structural Steel
•
Masonry Joints
•
Poured Concrete
DO NOT try to fasten into any other
type of materials. It can cause serious
injury or blindness.
Unsuitable Base materials that should
not be fastened to:
Never try to fasten into very hard or
brittle materials such as tile, glass, cast
iron or rocks of any kind. These
materials can break or shatter causing
spall and may cause serious injury to the
tool operator and the bystanders.
Never fasten directly to a base
material easily penetrated like
wood or gypsum board. These
types of materials may cause the
fasteners to penetrate through to the
other side making it dangerous for
other people in the work area.
Never fasten into a base material
that fails the center punch test.
Failure to check the suitability of the
base material can cause serious
injury to the eyes or other body parts.
Never try to fasten into very hard
or brittle materials.
Never fasten directly to a base
material easily penetrated like
wood or gypsum board.
08
Center Punch Test
MUST WEAR EYE
PROTECTION WHILE
PERFORMING THIS TEST.
1.
Always check the hardness of the
base where you want to fasten.
2.
Using a fastener as a center punch,
strike the fastener with a hammer
against the work surface and check
the results.
Center Punch Test Result
1.
The material is too hard for a powder
actuated fastening, if the fastener point
is flattened.
2.
The material is too soft, if the fastener
easily penetrates it.
3.
The material is too fragile, if the
material cracks or shatters.
4.
The material is suitable for powder
actuated fastening, if the fastener
causes a small indentation in the
material.
Selection of Loads and Safety
1.
Always make a fastening test after
ensuring that the base material is
suitable to determine the appropriate
power level. If excessive power is used,
the fastener may pass completely
through the work material, causing
death or severe injury to someone who
may be in the path of the fastener.
2.
All operators must always select the
level of the loads by the power level
number to avoid the use of incorrect
loading.
Safety at Work
1.
Operators and bystanders must always
wear approved ear and eye protection.
Failure to do so can cause blindness or
serious eye injury from debris, and
hearing loss from exposure to constant
or repeated noise from the fastening
tool.
2.
Keep the work area clear of
unnecessary materials and bystanders
that may interfere with the safe
operation of the tool. Operating tool in
a congested or disorganized area may
affect the ability to operate safely.
3.
Never operate the tool when explosive
or inflammable materials are close.
Powder loads may create sparks when
fired and could ignite these materials or
vapors.
4.
Always provide warnings within 50' of
the area where fastening is taking
place: " CAUTION - Powder Actuated
Tool In Use". Failure to warn others can
result in serious injury or death to them.
Contact your supervisor for this sign.
Powder actuated
tool in use
09