- ページ 4

ラボラトリー機器 CytoTherm CT-4TのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。CytoTherm CT-4T 10 ページ。

OPERATION

Wait for the water to heat up to 37.0

For your protection, use gloves when working with any blood products.

Flat-frozen plasma units can be thawed without an overwrap bag. Hold a

bag of flat-frozen plasma (bare or overwrapped) with the ports up and the

label on the plasma unit away from the center of the CORRAL. Slip the

CLAMP (plastic bar with a stainless spring attached) over the top of the

bag and line up the 3 grooves in the CLAMP with the ports of the plasma

bag.

Place the bottom of the plasma bag into the water, between the stainless

rods of the CORRAL. Pull the stainless spring of the CLAMP over the

screw head in the CORRAL. The spring should pull the plastic bar and

plasma bag snugly against the corral. The spring tension can be adjusted

by bending the stainless steel spring. If the stainless steel spring breaks,

the clamp must be replaced (Part # C4T-CLM).

Folded frozen plasma must be overwrapped. Load it the same way. The

CLAMP will hold the plasma unit by the overwrap bag.

Push START to begin thawing for the programmed time. The Rocking

Motor will turn on. The water in the bath will be forced to flow through

the large holes in the dividing plate of the CORRAL and will massage the

plasma bags.. Use PLUS or MINUS to increase or decrease the thawing

time. When the time is finished, the buzzer will call the operator back.

The STOP switch ends the thawing. If more thawing time is needed, hold

PLUS while pushing START and the unit will thaw for another 3 minutes.

If a Plasma bag leaks, turn the unit off and discard the leaking bag. The

remaining bags are not contaminated, because the ports are always kept

out of the water. Dry off the plasma bags with paper towels and wipe with a bleach towelette or a 10% bleach

solution. The bath water is contaminated and must be drained and the bath cleaned. See MAINTENANCE.