- ページ 2
ソナー Blueprint Subsea ArtemisPROのPDF クイック・リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Blueprint Subsea ArtemisPRO 4 ページ。
ページを印刷する
BATTERY PODS & POWER
Charging
Batteries
To Turn Power ON
20s
Batteries will
self-discharge
in storage.
Charge Battery Pod
before use.
USB PORT
Accessing The USB Port
Pull rear chassis cover outwards to access the USB connector.
USB Cover &
Blanking-Plug
Connecting the Satellite (GNSS) Float
USB
Connector
Ensure the float cable is secured
to the diver or chassis and no
strain is placed on the connector.
Charge Status Indicators
approx 4h
1
Not Connected or Initialising
Yellow
Fast Charge
Orange
Top-off Charge
Green with Yellow Pulse
Complete (Trickle Charge)
Green
Error (Charging Stopped)
(turn off and leave Battery Pod
to cool for one hour minimum)
Orange and Green Flashing
To Turn Power OFF
Power
23/04/2016
Tools
15:45:01
Sonar
Missions
artemis
Navigation
pro
Markers
Vision
Dive Logs
Diver
Start Dive
www.blueprintsubsea.com
v2.0.1234
Refer to manual for full Battery
safety and usage instructions
USB
Connector
Connecting Batteries
PRESS
BEFORE
USE
2
"OFF"
Connecting The USB Cable
Use the USB Adapter Lead and USB Cable
to connect ArtemisPRO to a PC.
USB Connector
You will need to install RNDIS drivers when
connecting a PC to ArtemisPRO for the first time.
See the manual for further details.
Replacing The Chassis Cover & Blanking Plug
Press Pressure Relief Valve firmly
before use to check it is sealed.
Battery groove
clicks into place
to secure.
Power
Charge:
Estimated Life:
Sonar System:
73%
04:18
ON
Voltage:
Power Drain:
Vision System:
14.5V
26.1W
OFF
System Status:
Power Mode:
LOW POWER
SONAR
DVL
FLOAT
CAMERA
LIGHT
Power:
Heading:
Depth:
Selected Marker:
Distance:
Altitude:
217°
8.4m
374m
32.7m
Target 2
Turn Power Off
Are you sure you want to turn the power off?
This will stop any logging any may loose your
position until a new fix is obtained.
POWER OFF
USB Adapter Lead
PC with NavPoint software
Navigate to "\\ARTEMISPRO"
Always replace the Chassis Cover and
USB Blanking Plug after use!
This stops the connector pins from getting
wet, preventing damage and corrosion.
Insert Battery Pod
fully into the chassis.
Ensure connectors
align and mate fully.
DiveLog:
CANCEL
USB Cable
: