ページを印刷するASSEMBLY
Handlebar (required tools: 5mm hex key)
Do not carry the bike or move the fork during the
handlebar assembly process. The fork must be fully
inserted into the frame.
1. Unscrew the retainer from the head tube.
2. Remove the silver spacer from the head tube.
3. Insert the handlebar stem into the head tube and
tighten the retainer.
(recommended torque 8 N.m)
4. Align the handlebar with the front wheel and tighten
the two bolts on the side of the stem.
torque 12N.m)
Front Wheel
1. Remove the brake pad protector located between the brake
pads.
2. Assemble the wheel by inserting the disc brake rotor between
the brake pads, then insert the fork end onto the wheel axle.
3. Remove the nut and spring (A) from the quick release skewer
4. Insert the quick release skewer with spring (B) pointing inward
into the right side of the wheel axle.
5. Insert spring (A) pointing inward into the left side of the quick
release skewer and tighten the nut.
6. Close the quick release lever and tighten by turning
clockwise.
(recommended
1. Unscrew !
retainer
2. Remove silver
spacers
(The quick release skewer is attached on the tire)
3. Remove nut and spring
(A)
5. Tighten
(B)
4. Insert
6. Close
7
U S E R M A N U A L