- ページ 4

セキュリティセンサー Egardia Flood detectorのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Egardia Flood detector 4 ページ。

ページを印刷する
2.
Remove the backing from the adhesive strip of the mounting fixture and secure it firmly onto
the desired location and height.
3.
The flood detector can be mounted using the screws or placed in the right location.
4.
For mounting with screws:
a.
Remove the two screws at the top and bottom of the flood detector and remove the
cover.
b.
Use the pre-punched holes in the back plate of the flood detector as a template to
mark the drill holes on the desired location.
c.
Drill the holes and use the plugs for stone or plaster walls.
d.
Secure the back of the flood detector using the screws.
e.
Replace the cover and secure with the two screws at the top and bottom.
STEP 4: CHECK AND TEST
To make sure that the flood detector functions correctly it is advisable to test the flood detector.
Make water contact with the sensor of the flood detector. If the alarm is triggered the flood detector
has been installed correctly.
Congratulations! The installation is complete.
MAINTENANCE
Batteries
The flood detector is powered by four 1,5V AAA alkaline batteries. Depending on use, the average
life of the batteries is 2-4 years. The flood detector itself will indicate when the batteries are low.
When the batteries have power left for about one month you will receive the following warnings:
1.
In your Egardia account you will see the message "Battery low level" under the tab "Alarm
history".
2.
You will receive a one-time message by telephone, SMS or email.
3.
The central indicator light (Alarm) of your gateway is lit yellow. After the batteries have been
replaced the gateway will return to normal status.
Replacing the batteries
1.
Ensure that the alarm is turned off.
2.
Remove the two screws at the top and bottom of the flood detector and remove the cover.
3.
Remove the old batteries and replace by four new 1,5V AAA alkaline batteries. Ensure that the
battery polarization is correct.
4.
Replace the cover and secure with the two screws at the top and bottom.
3