- ページ 6

食器洗い機 Asko D3122のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Asko D3122 16 ページ。 D3122 use & care guide fr (french ucg 2+1 warranty)
Asko D3122 にも：取付説明書 (12 ページ), クイック・スタート・マニュアル (2 ページ), (スペイン語) 操作とケア (16 ページ), (フランス語) 使用マニュアル (16 ページ)

ページを印刷する

RINSE AID DISPENSER

The rinse aid is released during the final rinse to prevent

water from forming droplets on your dishes that can leave

spots and streaks. It also improves drying by allowing

water to "sheet" off the dishes.

ASKO dishwashers are designed to use liquid rinse aids.

The rinse aid dispenser is located inside the door next

to the detergent dispenser. (See illustration on page 3.)

To fill the dispenser, open the cap and pour the rinse aid

into the dispenser until the level indicator turns completely

black. The dispenser holds about four ounces of liquid

rinse aid.

Be careful not to overfill the dispenser, because this could

cause oversudsing. Wipe away any spills with a damp

cloth. Don't forget to replace the cap before you close

the dishwasher door.

If you have soft water, rinse aid may cause a white film

to develop on your dishes. You may not need rinse aid.

NOTE:

If you use a dishwashing detergent with a

rinse aid additive, you should not fill the

rinse aid dispenser. This could cause a

film on your dishes.

ADJUSTING THE AMOUNT OF RINSE AID DISPENSED

A measured amount of rinse aid is released during the

final rinse. As with detergent, the amount of rinse aid

needed for your dishes depends on the hardness of the

water in your area. (See page 5.) Too much rinse aid

can result in lather or foaming and cause cloudiness or

streaks on your dishes. If the water in your area is very

soft, you may not need rinse aid. If you do, you can

dilute the rinse aid with an equal amount of water.

Rinse aid

adjustment dial

WHEN

WHEN T T T T T O REFILL

WHEN

O REFILL

O REFILL THE RINSE

WHEN

O REFILL

The black dot on the rinse aid dispenser indicates the

amount of rinse aid in the dispenser. As the rinse aid

diminishes, the size of the black dot decreases. You

should never let the rinse aid get below 1/4 full.

Page 6

THE RINSE

THE RINSE AID DISPENSER

THE RINSE

AID DISPENSER

THE RINSE

AID DISPENSER

Rinse Aid Level Indicator

To open the dispenser, turn the cap to the "open" (left)

arrow and lift it out.

Pour the rinse aid into the dispenser, being careful not to

overfill.

Replace the cap by inserting it aligned with "open" arrow

and turning it to the closed (right) arrow.

The rinse aid dispenser has six settings. Always start

with the dispenser set on "1." If spots and poor drying

are problems, increase the amount of rinse aid dispensed

by removing the dispenser lid and rotating the dial to

"2." If the dishes still aren't drying properly or are spotted,

adjust the dial to the next higher number until your dishes

are spot-free.

To increase the amount of rinse aid released in the

final rinse, turn the adjustment dial to the next

higher number.

NOTE

: : : : :

Only adjust the dial one number at a time.

As the rinse aid diminishes, the size of the black dot

on the rinse aid level indicator changes, as

illustrated below.

Full

3/4 full

1/2 full

1/4 full - Should refill to eliminate spotting

Empty

Open

Closed

Dispenser

Cap