- ページ 7

メディアプレーヤー Ambery HDV6のPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。Ambery HDV6 7 ページ。 Hdtv multimedia av center

ページを印刷する

system back to the manufacturer default setting.

9. 【P.M】 Picture mode . Press "P.M" for picture mode selection. Three picture modes,

Clear, Normal and Dark are available for selection.

10. 【N.R】 Noise reduction. Press "N.R" for selecting different noise reduction level. Three

levels of noise reduction mode are available for selection.

11. 【Aspect】 Press "Aspect" button to switch from 4:3 standard mode to 16:9 widescreen

mode.

* When the aspect ratio of original input signal is 16:9, only 16:9 aspect ratio will

be showed.

* This aspect ratio adjustment is not available when VGA input is selected.

Note: The left and right keys on the remote controller can be used as audio volume control

keys. Press the left key to turn down the volume. Press the right key to turn up the

volume.

TROUBLE SHOOTING

1. No picture output on the display ?

 Make sure that all the cable connections are correct and connected well.

 Check the quality of the cable used.

 When seeing no computer screen on the TV or other HD display, please check the computer

video card resolution setting in the PC or Mac and make sure that a proper supported VGA

resolution is selected. Refer to page 3 for the supported VGA video card resolutions.

 Try power cycling the HDV6 by unplugging the power supply and then reconnecting the power.

Supply again.

 Try pushing the "Reset" button from the HDV6 unit to restore to the system default again.

2. Only picture displayed but no sound ?

 Make sure that all the cable connections are correct and connected well.

 Check the quality of the cable used.

 If the AV device has HDCP encrypted, the signal may not match very well with this multimedia

center unit at first connection. In that case, please try resetting or power cycling your HDV6

again for proper sync up.

 Please be advised that HDCP protected content is not allowed for recording. Make sure that

you do not connect the output from this HDV6 unit to a video recorder since the HDMI output

from a HDCP-ready device such as blue-ray DVD or digital cable box will automatically lock

up the audio part.

3. My HDV6 does not respond to remote control or manual push buttons ?

 Please unplug the power cord to reset HDV6.

4. Set the output at 1080p from the HDV6 but it is not showing on my plasma ?

 Please make sure that both of your source device and TV display end are fully supporting

1080p.

5. Why the TV could not display the 1080i output from my HDV6 unit ?

 When up-scaling the video signal to the 1080i level, some LCD TVs or other flat panel

displays may not support the interlaced video unless the 1080i is de-interlaced before

showing on the screen under that circumstance. If 1080i can not show on your TV, please

change the output resolution from your HDV6 to 720p, 1080p etc. to match what TV supports.

NOTICE

 Manufacturer reserves the right to make changes in the hardware, packaging and any

accompanying documentation without prior written notice.

 HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered

trademarks of HDMI Licensing LLC.

 HDV6 incorporates HDMI

 Trademarks and brand names are the properties of their respective owners.

technology.