- ページ 12

食器洗い機 Asko D5233XXLのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Asko D5233XXL 16 ページ。 Tall tank models
Asko D5233XXL にも：プランニング・デザイン・マニュアル (1 ページ)

ページを印刷する

ADJUSTING THE LEVELING LEGS

Now that all the connections are made and the machine

is in place under the cabinet, you should make the final

height adjustment.

1. You should set the rear

foot first. To do this, use a

screwdriver to rotate the

adjusting screw on the

bottom front of the machine.

Turn the screw clockwise to

raise the foot and counter clockwise to lower it.

FASTENING THE DISHWASHER TO THE CABINET

NOTE:

If you want to mount a wooden door or a custom panel.

Do this before fastening the dishwasher to the cabinet!

See chapter "Fitting custom door panel"

It's necessary to fasten the dishwasher to the cabinet so

it won't tilt when the door is opened or if something heavy

is placed on the door. Use only the stainless steel screws

provided with the machine.

Use option A for U.S. or European

standard installations. Use option

B only for European standard

installations, or U.S. installations

where there is a hard counter-top

such as tile or marble.

Cover the screw heads with the plastic plugs provided

with the machine.

When the machine is properly attached, check

that the feet are tight against the floor and that the

machine is level.

NOTE:

Be sure to use white spacers to keep from over-tightening

the mounting screws.

INSTALLING THE TOE KICK

SETTING THE TOE KICK DEPTH

1. Press the grey catches towards each other to release

the toe kick brackets.

2. Pull out the toe kick brackets as far as the installation

requires to provide the proper toe kick depth.

3. Once the toe kick brackets are at the appropriate depth,

press the grey catches away from each other to lock

the toe kick brackets in place.

4. The back side of the toe kick has hooks that will hang

the toe kick on the toe kick brackets. Lift the toe kick

up and let the hooks slide onto the brackets as you

lower the toe kick to the floor.

2. Using a 5/8" (16 mm) wrench, adjust the locking nuts

until the machine is level. (The machine may have an

inclination of 3/16" (5mm) maximum without affecting

its performance.)

3. When the feet are properly adjusted, tighten the

locking nuts to the base pan.

NOTE

When it is not possible to attach the dishwasher to the

cabinet, you should install tip guards. (See "Tip Guards"

on page 2.):

Customer Care Center

1-800-898-1879

www.askousa.com

Page 1