- ページ 7
カメラアクセサリー Blueshape BG190HDのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Blueshape BG190HD 16 ページ。 Professional broadcast 3-stud camera batteries
ページを印刷する
The battery's energy is conserved during operation, stand-by and low
capacity states through intelligent power mode management. When
the pack capacity is very low, it enters automatically into "shutdown
mode" to minimise further capacity losses and prolong cell life. The
LED indicator is permanently off and the pack can only be re-
activated by charging.
Wi-Fi enabled: this new, advanced BLUESHAPE technology permits
users and rental houses to be in command of their battery fleet
through a free App available for iOS and Android, called "GRANITE
Link"
The battery will shut down if the maximum specification discharge current
for the model in use is exceeded. It will reset approximately 30 seconds
after the excessive load has been removed. The battery will also shut
down when fully discharged but will reactivate upon charging. Pre-Charge
is enabled on all batteries to limit the charging current and gently charge
low voltage cells.
Further precautions
Please consult your vendor before use, to ensure compatibility with
your equipment. Although the battery has been designed for use with
most standard 3-Stud enabled equipment, there may be instances
when the battery may not be compatible.
Never attempt to open or dismantle the battery
Opening the battery during warranty will automatically invalidate the
guarantee
Do not short circuit the battery even though it is short circuit protected
Do not use the battery in extreme temperature environments
Keep the battery away from fire to avoid explosion
Charging
The battery can be charged using original or BLUESHAPE 3-Stud
chargers. Consult your vendor if you intend to charge the battery using
third-party chargers.
Since the battery is normally shipped in ultra-low power consumption
mode, IT NEEDS TO BE CHARGED BEFORE FIRST USE.
This series of 3-Stud mount batteries feature a digital communication with
the chargers. When the battery is installed on chargers, it is important that
the internal electronic is active and running for the battery to be detected
correctly and the charge session to start. In the event that the charger
remains in the "Evaluate" state, push the LEDs button once, to activate
the battery communication circuitry.
The battery may become hot during charging. This is normal. Consult
your vendor if during charging, the battery becomes excessively hot or
stops charging. Charging is only allowed at temperatures between 0°C
- 7 -