- ページ 3

ヒーター Ambia ACH-220のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Ambia ACH-220 7 ページ。 Two zone tower ceramic heaters

ページを印刷する

13. Do not insert or allow foreign objects to enter any ventilation or exhaust

opening as this may cause an electric shock or fire, or damage the heater.

14. To prevent a possible fire, do not block air intakes or exhaust in any

manner. Do not use on soft surfaces, like a bed, where openings may

become blocked.

15. A heater has hot and arcing or sparking parts inside. Do not use it in the

areas where gasoline, paint, or flammable liquids are used or stored.

16. Use this heater only as described in this manual. Any other use not

recommended by the manufacturer may cause fire, electric shock, or

injury to persons.

17. Avoid the use of an extension cord because the extension cord may

overheat and cause a risk of fire. However, if you have to use an

extension cord, the cord shall be No. 14 AWG minimum size and

rated not less than 1875 watts.

18. The output of this heater may vary and its temperature may become

intense enough to burn exposed skin. Use of this heater is not recom-

mended for persons with reduced sensitivity to heat or an inability to

react to avoid burns.

SAVE THESE INSTRUCTIONS.

TECHNICAL SPECIFICATIONS

Power: 12.5A / 120V / 60Hz

Wattage: 1500 (+5% / -10%)

Note: 750W each module

2. OPERATING INSTRUCTIONS

SITUATING YOUR TWO ZONE HEATER

Your heater has been designed with a variety of use situations in mind.

The basic uses are:

1. Combined: Both heat modules attached to each other, used as a single

heat source.

2. Separated: Each heater module in a different position, connected by the

interconnect tether.

3. Independent (ACH-260 Only): Use the two modules as completely

separate heaters.

COMBINED

Place the heater where desired, taking careful note of the safety guidelines

listed in Section 3 of this manual. Please see the Controlling Your Heater

section for further instructions.

TETHERED

A unique aspect of your Two Zone Heater is the ability

to locate the two heater modules in separate locations.

To separate modules:

1. Hold the TOP MODULE by the handle with one hand,

and place other hand on the rear top surface of the

BOTTOM MODULE.

2. Pull the TOP MODULE forward, tilting the back of the

TOP MODULE up and away from the BOTTOM MOD-

ULE.

3. Once the rear of the TOP MODULE is clear of the BOT-

TOM MODULE, lift it up and the modules will separate.

To combine modules:

1. Hold the TOP MODULE by the handle, tilting the module

down in front at about a 45 degree angle.

2. Lower the front edge of the TOP MODULE down so the

locking tabs fit into the receiving tabs on the BOTTOM

MODULE.

3. Once the tabs have engaged, lower the rear of the TOP MODULE until it is firmly

seated.

To separate

To combine