- ページ 4
ヒーター Ambia ACH-260のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Ambia ACH-260 7 ページ。 Two zone tower ceramic heaters
ページを印刷するTo make routing the interconnect cord
easier, it can be disconnected from the base
unit, and reconnected after you've located
the module where you want it.
INDEPENDENT (ACH-260 ONLY)
The ACH-260 cord connection is a standard
wall plug head. You may plug the satellite
module in to any regular outlet, and con-
trol it independently from the base unit – a
completely separate heater. The base has a
standard AC outlet – remember never to
plug anything other than the satellite
heater module into this outlet.
3. CONTROLING YOUR HEATER
ACH-220 Controls
DISPLAY: indicates the set desired
temperature
POWER button: cycles through the
various power settings for the heater.
Position 1 powers both modules. Position 2 powers only the BOTTOM
MODULE, and Position 3 powers only the TOP MODULE. HOLD THE BUTTON
DOWN FOR 3 SECONDS TO TURN HEATER OFF.
AUTO button: toggles between manual mode and AUTO thermostat control.
When first connected, the unit is in manual mode; the modules run continu-
ously until turned off. One press switches to AUTO, which allows you to set a
desired temperature using the TEMP + and TEMP - buttons. The AUTO light on
the control panel indicates when the heater is in AUTO mode.
UP button: TEMP + button: increases the set desired temperature for
AUTO mode. YOU MUST FIRST SELECT AUTO MODE FOR THIS TEMPERATURE
SETTING TO CONTROL THE HEATER.
DOWN button: TEMP - button: decreases the set desired temperature
for AUTO mode. YOU MUST FIRST SELECT AUTO MODE FOR THIS
TEMPERATURE SETTING TO CONTROL THE HEATER.
ACH-220 tether connection
6
ACH-260 Dual
Climate Control
Each module of the ACH-260 has an independent control panel. The
controls function differently when the modules are Combined as one heater,
and when they are separated.
COMBINED: The controls on the top
module manage the entire heater as
follows:
Display: indicates the set desired
temperature
POWER button: cycles through the various power settings for the heater.
Position 1 powers both modules. Position 2 powers only the BOTTOM MODULE,
and Position 3 powers only the TOP MODULE. HOLD THE BUTTON DOWN
FOR 3 SECONDS TO TURN HEATER OFF.
AUTO button: toggles between manual mode and AUTO thermostat control.
When first connected, the unit is in manual mode; the modules run continuously
until turned off. One press switches to AUTO, which allows you to set a desired
temperature using the TEMP + and TEMP - buttons. The AUTO light on the
control panel indicates when the heater is in AUTO mode.
UP button: TEMP + button: increases the set desired temperature for
AUTO mode. YOU MUST FIRST SELECT AUTO MODE FOR THIS TEMPERATURE
SETTING TO CONTROL THE HEATER.
DOWN button: TEMP - button:decreases the set desired temperature for
AUTO mode. YOU MUST FIRST SELECT AUTO MODE FOR THIS TEMPERATURE
SETTING TO CONTROL THE HEATER.
TETHERED OR INDEPENDENT: Both modules can be independently powered
and adjusted as follows:
DISPLAY: indicates the set desired temperature
POWER button: One push turns the module on. Holding the button for
3 seconds turns the module off.
AUTO button: toggles between manual mode and AUTO thermostat control.
When first connected, the unit is in manual mode; the modules run continuously
until turned off. One press switches to AUTO, which allows you to set a desired
temperature using the TEMP + and TEMP - buttons. The AUTO light on the
control panel indicates when the heater is in AUTO mode.
7