- ページ 5

ラック＆スタンド d&b audiotechnik Z54003のPDF 取付方法をオンラインで閲覧またはダウンロードできます。d&b audiotechnik Z54003 20 ページ。

1.3. Intended use

The d&b Z5402 Wall mount M and Z5403 Wall mount L must

only be used in conjunction with the d&b xS-Series loudspeakers

8S, 10S/10S-D and 12S/12S-D as described in these mounting

instructions.

The wall mounts allow both horizontal or vertical mounting of the

cabinets as well as vertical and horizontal alignment.

Mounting options

The tilt unit [6] of the wall mount can be rotated through 90°

allowing the cabinet to be mounted either vertically (a) or

horizontally (b).

To change the orientation of the tilt unit, proceed as follows:

Tools required:

▪ Open-ended spanner/wrench (size #13)

▪ Allen hex key (6 mm)

1. Slacken and undo the self-securing nut [1] and remove the

fixing bolt [2].

2. Remove the tilt unit [3] and turn it through 90°.

3. Refit the tilt unit in reverse order.

Mounting plate

NOTICE!

Only use mounting parts (fixing anchors and screws) that are

suitable for the intended application.

Observe the occurring extraction forces acting on the fixing

anchors and screws. The rated extraction force is 350 N.

A corresponding fixing template is supplied with these mounting

instructions. Refer to Þ Chapter 2. "Fixing templates"

on page 8.

An additional 20 mm (0.8") centered hole is provided on the

mounting plate as a feed-through for the connection cable. The

cable can be fed through the mounting plate into the boom arm

that acts as a cable run.

d&b Z5402/03 Mounting instructions 1.1 en