ページを印刷する
PREPARING THE DISHWASHER FOR INSTALLATION
At this point the styrofoam, plastic wrap, and the wood
pallet (base) should be removed from the dishwasher.
Now is an excellent time to inspect for any shipping
damage. Should you find any damage, you should report
it to your dealer or builder immediately.
Be sure to remove the toe kick and toe kick insulation (only
on certain models) from the top of the dishwasher.
SLIDES FOR LEGS
The unit comes with white plastic slides for the legs to
protect the kitchen floor from being damaged when you
slide the unit into place. The slides simply snap onto the
bottom of the legs.
Use caution when sliding the
dishwasher into place. The protec-
tive slides could cause damage to
certain types of soft flooring.
ATTACH THE LIGHT SHIELDING FILM
(Only certain models.)
Attach the light shielding film (packed in the document
bag) to the underside of the countertop above the touch
buttons.
NOTE:
The surface on which the protective film is to be attached
must be clean and dry.
MOVING THE MACHINE INTO PLACE
WARNING!
Make sure you put the protective slides on the legs to
prevent damaging the floor when you slide the unit into
place (see page 9).
As you do this, feed the drain line and inlet hose into the
access hole(s) in the side of the cabinet. Use caution
when sliding the dishwasher into place. The protective
slides could cause damage to certain types of soft flooring.
WARNING!
Be careful of sharp edges.
Page 9
ATTACH THE SUPPLIED DOOR SEALING
(Only certain models.)
This strip is an essential part of the Turbo Dry Express
system and must be installed to ensure an optimum
seal between the dishwasher tank and door.
1
2
Customer Care Center
1-800-898-1879
www.askousa.com
1
3
2