屋外ライト bluesmart SN SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。bluesmart SN Series 2 ページ。 All in one solar street light

ページを印刷する

Installation

2. Rotating platform:

1. Elliptical bracket: Use Φ5mm wrench

6 screws, fix the 360° rotating platform on the lamp

and 6pcs M6x16 screws to fix the elliptical

according to the direction of the road, and fix the

bracket on the solar panel.

screws

3. Combination: Use Φ6mm wrench and 1set M8x100 screws and 2pcs M8x30 screws to fix the multi-angle

bracket buckles after adjust the suitable angle, make sure the solar panel will absorb max sunshine.

4. Install the light: Use Φ6mm wrench to loosen the 6pcs screws, install the lamp into the pole and fix screws

(Horizontal installation: Use Φ6mm wrench loosen the screws of universal wheel and then turn to Horizontal 90°

angle, after that fix it.)

φ76mm

90°

Vertictal installation

Horizontal installation

5. Connection: Last step just connect the

waterproof cable from solar panel to lamp

body.

Using Instructions:

Clean surface of solar panel regular such as dirty leaves, oil, ect,

ensure high photoelectric conversion efficiency.

Set suitable angle towards sun. (≈local latitude)

Use 5mm wrench to loosen

Please avoid solar panel being shielded by buildings, trees, antenna

mast or other obstructions, otherwise it will reduce working efficiency

of solar panel , resulting in lower system efficiency.

Recharge battery every 3 month at least if it is idled.

Charge temperature of Lithium battery is from 0°C to 55°C, the discharging

temperature is from -20°C to 60 °C, make sure that ambient temperature

is in this range when used, avoid damage to lithium battery.

Clean snow on solar panel surface timely in winter.

How to activate the lamp after receiving the goods?

If you receive the goods in the daytime, connect the waterproof cable

between solar panel and lamp body, press the remote " ON" button, the

lamp will turn on for one minute and then turn off, that's activate the

lamp successful (no matter the solar panel receiving sunlight or not)

If you receive the goods in the daytime, connect the waterproof cable

between solar panel and lamp body, take whole set lamp out for absorb

the sunlight and wait for 3 minutes. When the sensor indicator light

appear red flash, the activation is successful.

If you receive the goods at night, connect the waterproof cable between

solar panel and lamp body, press the remote " ON" button, the lamp will

turn on for 12hrs, you can press "OFF" button if you want it turn off.

User Manual-SN Series

All In One Solar Street light

bluesmart