コントロールユニット 1010music LaserboxのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。1010music Laserbox 3 ページ。

Laserbox is firmware for the toolbox synthesizer module by 1010music. You

can learn how to install new firmware on our forum here:

https://forum.1010music.com/forum/products/firmware-downloads/511-how-

to-install-firmware-on-toolbox

You can find the download link for laserbox on our forum after you have

registered for the forum and clicked the email link to validate your account:

https://forum.1010music.com/forum/products/firmware-downloads

With laserbox, you can drive a laser by generating patterns, using premade

image wave files, or via CV signals received from other Eurorack modules.

You can also use external CV signals to modulate the signals sent to the laser.

You can use modulation to control the shape of the wave signal, the colors, the

position of the projection, and the rotation of the projection. Laserbox lets

you see the impact of your tweaks on the image by displaying a preview on screen. This allows you to design your laser show while the

laser is disconnected, and save the settings you like as presets.

What You Need

You can try out laserbox by installing the laserbox firmware on a toolbox Eurorack module and watching the preview. When you are

ready to send the signal to a laser, you will need the following:

Cyclops module by LZX Industries

•

Laser that supports ILDA input

•

5 mini TS cables (patch cords)

•

Alternatively, Laserbox could be used to drive any device that accepts +/-5 Volt CV signals for X and Y Coordinates, along with R,G,

and B color signals.

Laserbox Outputs

Laserbox sends X, Y, R, G and B signals through the control voltage

outputs on the front panel of toolbox. Connect the following outputs

of Control Box to the indicated inputs of the Cyclops module:

Toolbox Output

CV Output 3

CV Output 4

CV Output 6

CV Output 7

CV Output 8

Presets

Toolbox comes with a number of presets that demonstrate some of the capabilities of laserbox. The preset name is displayed at the

top of the screen. You can advance through the presets by touching the "-" and "+" buttons on either side of the preset name. You

can select from a list of presets by touching the name of the preset. This will display the Preset management screen where you can use

the control knobs to scroll through the list of available presets, and then touch LOAD to open the selected preset. You can work use

the Preset management screen to save changes to your preset, rename a preset, or create a new preset. Note: laserbox does not

automatically save your changes as you work. You must manually save your work before switching presets or turning of the module or

else your work will be lost.

12/12/18 5:16 PM

Laserbox User Guide

Cyclops Input

Laserbox User Guide p. 1