- ページ 5

ウェザーステーション Ambient Weather WS-1171のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ambient Weather WS-1171 17 ページ。 Advanced weather station

2.4.3 Sensor Operation Verification

Verify the indoor and outdoor humidity match closely with the console and sensor array in the same

location (about 10' apart). The sensors should be within 10% (the accuracy is ± 5%). Allow about 30

minutes for both sensors to stabilize.

Verify the indoor and outdoor temperature match closely with the console and sensor array in the same

location (about 10' apart). The sensors should be within 4°F (the accuracy is ± 2°F). Allow about 30

minutes for both sensors to stabilize.

It is recommended you mount the remote sensor on a north facing wall, in a shaded area. Direct

sunlight and radiant heat sources will result in inaccurate temperature readings. Although the sensor is

water resistant, it is best to mount in a well protected area, such as an eve.

Use 3 screws to affix the mounting bracket to the wall with a precision screwdriver. Connect the

remote sensor to the wall bracket by snapping into place.

Note: The console has four keys for easy operation: SET key, ALARM key, MIN/MAX key and

+ key. There are four program modes: Quick Display Mode, Set Mode, Alarm Mode and Min/Max

Mode.

Any program mode can be exited at any time by either pressing the SNOOZE/LIGHT key (on the top

of the display console), or waiting for the 10-second time-out to take effect.

While in Normal Mode, press the SET key to enter the Quick Display Mode as follows (once for

outdoor temperature and dew point and twice for absolute pressure and relative pressure):

Display Outdoor Temperature and Dew Point. Press the MIN/MAX or + key to toggle

between outdoor temperature and dew point.

Version 1.8

Figure 3

Page 5