- ページ 10

ウェザーステーション Ambient Weather WS-1171AのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ambient Weather WS-1171A 20 ページ。 Advanced weather station

ページを印刷する

4.2.3 Setting Calibrated Temperature

Temperature is measured by a resistive thermal device (RTD) and is subject to electronic variation.

Temperature errors can also occur when a sensor is placed too close to a heat source (such as a

building structure, the ground or trees).

To calibrate the indoor or outdoor temperature, we recommend a mercury or red spirit (fluid)

thermometer. Bi-metal (dial) and other digital thermometers are not a good source and have their own

margin of error. Using a local weather station in your area is also a poor source due to changes in

location, timing (airport weather stations are only updated once per hour) and possible calibration

errors (many official weather stations are not properly installed and calibrated).

Place the sensor in a shaded, controlled environment next to the fluid thermometer, and allow the

sensor to stabilize for 24 hours. Compare this temperature to the fluid thermometer and adjust the

console to match the fluid thermometer.

To calibrate indoor or outdoor temperature, in the Set Mode with indoor or outdoor temperature

flashing, press the

key or MIN/MAX key to increase or decrease the temperature setting (in

increments of 0.1 degC or 0.18 degF) to match the calibrated or known temperature source.

Note: The remote (outdoor) thermo-hygrometer will always display the measured temperature

level and not the calibrated temperature level. Only the console will show the calibrated value.

Note: The dew point calculation is based on the calibrated temperature level.

4.3

Alarm Mode

4.3.1 Alarm Display

While in Normal Mode, press the ALARM key to enter the High Alarm Mode. Press the ALARM

key again to enter the Low Alarm Mode. Press the ALARM key again to return to normal mode (or

wait 30 seconds for the programming mode to timeout).

Note: After entering the ALARM mode, the console will display the high and low alarm

settings. If the value reads --.-- (dashes), the alarm is not active.

4.3.2 Alarm Programming

While in Alarm Mode, press the SET key to set the alarms. The following are high and low alarms:

High Alarm Limits:



Time alarm (hour/minute)



Indoor humidity high alarm



Indoor temperature high alarm



Outdoor humidity high alarm



Outdoor temperature / dew point high alarm



Pressure high alarm

Low Alarm Limits:



In the Low Alarm Mode press the SET key to select the following alarm modes:



Time alarm (hour/minute)

Version 1.10

Page 10