ページを印刷する
Using your Appliance
Description of control panel
A
B
Start/stop buttons.
A
B
Power level buttons
C
Preselecting power level buttons
Timer buttons.
D
Powering on
1
Press the start/stop button.
of the zone you wish to use.
2
A flashing 0 display and a beep
indicates that the cooking zone is
on. You can now choose the
desired power level. If you do not select a
power level, the cooking zone will
automatically shut off after a few seconds.
Off
Press the start/stop button for the cooking
zone used or the "–" power button until 0 is
displayed.
Adjusting the power level
Press the + or - power buttons.
When it is switched on you can move
directly to maximum power "12" by
pressing the "–" button.
Warning
- When the display shows "PC" (pre-heating), if you do not set the cooking power
level, the cooking zone will turn off.
- The pre-heating time is calculated automatically by your hob depending on the
cooking power level chosen.
- The pre-heating function cannot be used if the cooking power level is less than 6.
- If you press the power buttons while pre-heating is underway, this "pre-heating"
will be cancelled. You come back to normal power setting mode.
8
D
C
- Pre-selected power levels:
Low-heat button
High-heat button
- Preselecting the maximum power level:
Boost button
Boiling power level
Preheat
This feature allows you to raise the
temperature rapidly in the preparation
phase, so that you can proceed with your
cooking at the power level you have
chosen.
To use it:
- After setting the power to 12, choose the
"PC" pre-heating function by pressing the
"+" button a second time.
The display will show "PC".
- As long as this is displayed, you can
change your cooking power level.
- A Beep confirms the setting.
- The display flashes alternately between
"PC" and your cooking power level: you are
in the "pre-heating" phase.
- At the end of the automatic pre-heating
phase, your hob now only displays the
cooking power level that you had selected
originally. You have now come back to
normal cooking mode.
Tip
If you are using several receptacles on
the hob at the same time, try to use
cooking zones located on opposite
sides. On the same side, using the
booster in one zone automatically limits
the the cooking power level of the other
zone visible in the display. This
automatic limitation also applies when
the pre-heating function is used.
(power level 6)
(power level 10)