- ページ 5

時計 Ambient Weather RC-1200MTTHのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ambient Weather RC-1200MTTH 8 ページ。 12" radio controlled wall clock with temperature & humidity

ページを印刷する

Next, press and hold the M. SET button again until the time is two minutes ahead of the current time.

The clock will begin updating again after the M. SET button has not been pressed for two minutes.

The clock will attempt synchronization every two hours (1:00, 3:00, 5:00, 7:00, 9:00, 11:00, 13:00,

15:00, 17:00, 19:00 and 21:00). During synchronization, the second hand will operate properly.

10 Forced Radio Resynchronization

To force resynchronization from the atomic clock, press and hold the REC button for 3 seconds. The

hands will return to the 12:00 position.

The clock attempts to synchronize with the atomic clock for 12 minutes. If it synchronizes, the clock

sets properly. If it does not receive the signal from the atomic clock (very likely during the daytime),

the clock will begin running from the 12:00 position until the time synchronization is successful.

The clock will attempt synchronization every two hours (1:00, 3:00, 5:00, 7:00, 9:00, 11:00, 13:00,

15:00, 17:00, 19:00 and 21:00). During synchronization, the second hand will operate properly.

11 Temperature and Humidity Sensors

The clock includes a temperature and humidity sensor, as shown in Figure 2. The clock is intended for

indoor use only.

Figure 2

12 Maintenance

The device is maintenance-free, but should be cleaned occasionally. Only use a slightly dampened and

soft cloth to clean the housing. Do not use abrasives or solvents.

Version 1.0

Page 5