- ページ 16
目覚まし時計 Ambient Weather WS-8400のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ambient Weather WS-8400 18 ページ。 Clearview projection alarm clock with indoor temperature and color changing outdoor temperature
ページを印刷する
Problem
The wireless sensor communication has
been lost or is intermittent or will not sync
up.
The clock does not respond to commands.
The projection is fuzzy
The clock is dim when running on
batteries only.
The barometer reads Lo
8. Accessories
Accessory
TX-8300
9. Liability Disclaimer
Please help in the preservation of the environment and return used batteries to an authorized depot.
The electrical and electronic wastes contain hazardous substances. Disposal of electronic waste in
wild country and/or in unauthorized grounds strongly damages the environment.
Reading the "User manual" is highly recommended. The manufacturer and supplier cannot accept any
responsibility for any incorrect readings and any consequences that occur should an inaccurate reading
Version 1.3
©Copyright 2016, Ambient LLC. All Rights Reserved.
Solution
Make sure the transmitter is powered up and the
LED is flashing about once per minute. For cold
weather environments, install lithium batteries.
If the transmitter is not flashing, replace the
batteries.
Resync the console. Reference Section 5.15.
The maximum line of sight communication
range is 150'. Move the sensor closer to the
clock.
If the sensor assembly is too close (less than
5-10'), move the sensor away from the clock.
Make sure the remote sensors are not
transmitting through solid metal (acts as an RF
shield), or earth barrier (down a hill).
Move the clock away from electrical noise
generating devices, such as computers, TVs and
other wireless transmitters or receivers.
Move the remote sensor to a higher location.
Move the remote sensor to a closer location.
Radio Frequency (RF) Sensors cannot transmit
through metal barriers (example, aluminum
siding) or multiple, thick walls.
Press the reset button on the back of the clock
with an open ended paper clip or sharp tool.
Adjust the focus setting.
Press the snooze/light button or connect to AC
Power.
The product was only designed to operate at
altitudes less than 4,000 feet. Check your local
altitude.
Description
Additional wireless sensor.
Page 16