- ページ 12
クロックラジオ Ambient Weather RC-8365のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ambient Weather RC-8365 14 ページ。 Clearview radio controlled projection clock with indoor and outdoor temperature
ページを印刷する
Problem
The wireless sensor communication has
been lost or is intermittent or will not sync
up.
The clock does not respond to commands.
The projection is fuzzy
8. Accessories
Accessory
TX-8300
9. Liability Disclaimer
Please help in the preservation of the environment and return used batteries to an authorized depot.
The electrical and electronic wastes contain hazardous substances. Disposal of electronic waste in
wild country and/or in unauthorized grounds strongly damages the environment.
Reading the "User manual" is highly recommended. The manufacturer and supplier cannot accept any
responsibility for any incorrect readings and any consequences that occur should an inaccurate reading
take place.
This product is designed for use in the home only as indication of weather conditions. This product is
not to be used for medical purposes or for public information.
The specifications of this product may change without prior notice.
Version 1.0
©Copyright 2018, Ambient LLC. All Rights Reserved.
Solution
Make sure the transmitter is powered up and the
LED is flashing about once per minute. For cold
weather environments, install lithium batteries.If
the transmitter is not flashing, replace the
batteries.
Reset the console by disconnecting from AC
power, removing one battery from the clock,
wait 10 seconds, and reinsert the battery.
The maximum line of sight communication
range is 150'. Move the sensor closer to the
clock.
If the sensor assembly is too close (less than
5-10'), move the sensor away from the clock.
Make sure the remote sensors are not
transmitting through solid metal (acts as an RF
shield), or earth barrier (down a hill).
Move the clock away from electrical noise
generating devices, such as computers, TVs and
other wireless transmitters or receivers.
Move the remote sensor to a higher location.
Move the remote sensor to a closer location.
Radio Frequency (RF) Sensors cannot transmit
through metal barriers (example, aluminum
siding) or multiple, thick walls.
Press the reset button on the back of the clock
with an open ended paper clip or sharp tool.
Adjust the focus setting.
Description
Additional wireless sensor.
Page 12