- ページ 7

セキュリティシステム ACR Electronics OLAS COREのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。ACR Electronics OLAS CORE 12 ページ。 Testing the alarm
ACR Electronics OLAS CORE にも：精度テスト (2 ページ), セットアップとレンジテスト (4 ページ), トラブルシューティング (2 ページ), マニュアル (2 ページ), セットアップとレンジテスト (4 ページ)

4. OLAS MOBILE APPLICATION FEATURES (AVAILABLE FROM HOME SCREEN)

• Customise the OLAS transmitters name (press the unique number associated with the transmitter ~ eg.

OLAS Float-On 1670 - then type the custom name)

• Check OLAS tag battery status

• Enable/Disable OLAS transmitters

• Pause all tracking

5. PAUSE TRACKING

• Press the control switch for 2 seconds, release the control switch after a single beep

• When in Paused state the control switch will flash Red for 3 seconds ON/3 seconds OFF followed by a

sound signal

• Press the control switch once to re-start Tracking

• If an OLAS transmitter has been removed or switched off the Core will remain in Pause

6. ADDING AN OLAS TRANSMITTER (WITHOUT THE OLAS APP)

• Press the control switch for 2 seconds, release after a single beep, Tracking will be Paused

• Switch on the OLAS transmitter and hold it within 2 meters of the Core

• Press the control switch once, the control switch will flash Red for 10 seconds whilst scanning for new

transmitters

• The number of connected OLAS transmitters is indicated with a sound signal and Red flash per

transmitter

7. ADDING AN OLAS TRANSMITTER (WITH THE OLAS APP)

• Switch on the OLAS transmitter and hold it within 2 meters of the Core

• Open the home screen, press the + icon in the bottom corner, press "Scan for new transmitter"

• The control switch will flash Red for 10 seconds whilst scanning for new transmitters

• The number of connected OLAS transmitters is indicated with a sound signal and Red flash per

transmitter

• The home screen will update with the newly connected transmitters

8. REMOVE AN OLAS TRANSMITTER

• Press the control switch for 4 seconds, release after the second beep – this will switch off the Core

• Switch off the OLAS transmitter/s to be removed. OLAS transmitter are turned off by pressing the button

on the transmitter for 4 secs. The light on the transmitter will then flash red.

• Hold all remaining OLAS transmitters within 2 meters of the Core

• Press the control switch to switch the Core ON

• The Core will scan for 30 seconds while the control switch LED flashes Red to indicate scanning

• After 30 seconds, any OLAS transmitter within 2 meters of the Core will be tracked

• The number of connected OLAS transmitters is indicated with a sound signal and Red flash per

transmitter

• The control switch will illuminate Red to indicate the Core is Tracking