- ページ 4

室内暖炉 AMBIONAIR FLAME EF628のPDF 設置および使用説明書をオンラインで閲覧またはダウンロードできます。AMBIONAIR FLAME EF628 8 ページ。 Electric fireplace insert with remote control

INSTALLING YOUR FIREPLACE

When choosing a location for your new fireplace, ensure the general instructions are followed. For maximum

effect, install the fireplace out of direct sunlight.

It is safe to set the fireplace insert close to non-combustibles. DO NOT STORE OR USE GASOLINE OR

OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.

Please refer to the detailed instructions that come with the mantel that you purchased.

MODEL EF628

Fireplace Insert Size

Dimensions W x D x H

Fireplace Package size

Dimensions W x D x H

Gross Weight

Net weight

Voltage

Frequency

Watts / Amps

Heater Rating

A 15 Amp, 120 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this appliance.

Preferably, the fireplace insert will be on a dedicated circuit as other appliances on the same circuit may cause

the circuit breaker to trip or the fuse to blow when the heater is in operation. The unit comes standard with a 6 ft

(1.8 m) long 3 wire cord, exiting out the back of the fireplace insert. Plan the installation to avoid the use of an

extension cord. If an extension cord must be used, it must be a minimum 14 ga, 3 wire with grounding type plug

and connector and rated not less than 1875 watts. The extension cord shall not be more than 20 ft (6 m) in

length.

WARNING: Electrical outlet wiring must comply with local building codes and other applicable regulations to

reduce the risk of fire, electrical shock and injury to persons.

WARNING: Do not use this fireplace insert if any part of it has been under water. Immediately call a qualified

service technician to inspect the firebox and replace any part of the electrical system which has been under

water.

29.37" x 11.34" x 23.54"

31.5" x 13.58" x 26"

42.1lbs / 18.81 kg

36.4lbs / 16.5 kg

120 V

60 Hz

1400 W / 11.6 A

1300 W / 4436 BTU's