ACR Electronics OLAS CORE 정확도 테스트
{카테고리_이름} ACR Electronics OLAS CORE에 대한 정확도 테스트을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Electronics OLAS CORE 2 페이지. Testing the alarm
ACR Electronics OLAS CORE에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지), 설정 및 범위 테스트 (4 페이지), 문제 해결 (2 페이지), 매뉴얼 (2 페이지), 설정 및 범위 테스트 (4 페이지)
페이지 인쇄
Testing the alarm
1. Connect the OLAS app to the Core. For more
information on how to do this please refer to the Core Setup
Instructions.
3. Switch off the OLAS transmitters.
OLAS tag: press the button for 4 seconds, until a red flash is
seen. OLAS Float-On: press the button for 4 seconds until the bi-
color LED flashes red.
5. Press the control switch on the Core once or tap "Continue to
Recovery" in the App. This puts the system into pause state.
MOB
Tom
Overboard!
OR
Step 1
Press and hold the MOB button
on your GPS Chart Plotter
Step 2
Send a MOB DSC alert
using your VHF
Continue to recovery
www.acrolas.com
0438
Near
1152
Near
0347
Near
MOB
2. Ensure all OLAS transmitters are seen on the OLAS app
homescreen.
4. The alarm will occur after your set 'Alert Time'
The default Alert Time is 3 seconds.
6. Press the control switch again once. 3 beeps will sound
to indicate that the transmitter is still missing, and the
system is still in pause state.
0438
0347
Tom
Overboard!
Step 1
Press and hold the MOB button
on your GPS Chart Plotter
Step 2
Send a MOB DSC alert
using your VHF
Continue to recovery