Askoll PURE XL HC LED 사용 설명서 - 페이지 11

{카테고리_이름} Askoll PURE XL HC LED에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Askoll PURE XL HC LED 14 페이지. Marine aquarium kit
Askoll PURE XL HC LED에 대해서도 마찬가지입니다: 사용 설명서 (14 페이지)

페이지 인쇄

1. Starting up the System

PURE Aquarium KIT

6. MAINTENANCE AND CLEANING

WARNING

To avoid electric risk:

Disconnect the plugs of the electric devices from the

outlets before handling the product and/or immersing

the hands in water.

Never pull the cable of the electric devices to discon-

nect the plugs from the outlets. To disconnect them,

grab the plugs and pull them.

Do not connect the electric devices of the product to

the mains before having completed the installation or

having repositioned the same after maintenance op-

erations. Do not use the thermal heater and the pump

dry.

To avoid the risk of burns:

After disconnecting the plug, let the hot parts of the

thermal heater (about 30 minutes) and of the lighting

unit (about 5 minutes) cool down, before handling

them. On the thermal heater, the warning light indi-

cates only that the heating phase is active. When the

warning light is off, it does not mean that the thermal

heater is cool.

Check that the water level is always included in the

min. and max. level range indicated on the label.

After maintenance operations, if necessary, restore

the proper water level.

Do not use detergents or other chemical products

which may damage the product's components or con-

taminate the aquarium itself.

CAUTION

Always close the filter cover after the necessary oper-

ations have been performed, to prevent algae growing

on the filters due to their exposure to direct light.

6.1. Maintenance and cleaning jobs

Observe the indicated maintenance and cleaning schedule to keep

your product in excellent working order.

Frequen-

Every

week

Every 15

days

Every

month

Every 6

months

6.2. Rolling Filtration System

To keep the filters working properly and ensure the best water con-

ditions in the aquarium, Askoll recommends that you replace the

sponges and cartridges according to a specific maintenance sched-

ule, the Rolling Filtration System (RFS).

This can be done quite easily by purchasing the original Askoll

PURE MARINE FILTER MEDIA KIT maintenance kit from your trust-

worthy retailer (see product code under chapter 9). The Kit contains

1 sponge for mechanical filtration, 1 CARBON cartridge and 1 ZEO

cartridge.

Replace the sponges and cartridges as follows:

1) After disconnecting the plug of each electric device, open the

filter cover.

CAUTION

Perform a frequent and accurate cleaning (at least

once every 15 days) of parts affected by the salt

condensate. To remove the salt scaling that is most

difficult to clean, mere lemon juice can be used. Then

rinse thoroughly to remove any acid residues.

Part

Visually inspect the sponges; if they

Mechanical

are clogged, rinse them out or replace

filtration

them

Check that the water level is between

Tank

the MIN and MAX marks and top it up

as needed.

Replace the CARBON and ZEO car-

Chemical

tridges (par. 6.2 Rolling Filtration

filtration

System)

Replace the mechanical filter sponge

(2 sponges for the XL model). For the

Mechanical

L and XL models, replace the spong-

filtration

es closest to the water outlet nozzle

(par. 6.2)

Clean the pump unit (par. 6.3)

Pump unit

Job