Ambirad Vision VSO Series 조립 및 사용 설명서 - 페이지 14

{카테고리_이름} Ambirad Vision VSO Series에 대한 조립 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambirad Vision VSO Series 20 페이지. Radiant tube heaters

페이지 인쇄

Manifold Tube

FLOW

2.2.15 Fixing of optional End Mouldings.

If end mouldings (P) have been ordered

(optional item) fit the end mouldings with the

screws provided / quick release clips to the

holes in top of the canopy.

2.2.16 HB Manifold Assembly.

VSO Models ONLY. After fixing the heaters in

the desired position, the manifold system

requires fitting.

After allowing for a minimum of 75mm (3in) of

penetration of the fitting into the tube, cut the

tubes to the lengths required and remove all

burrs and wipe off any grease or oil with a clean

rag.

Method of jointing aluminium tube

Using the applicator gun exude 4mm diameter

bead of high temperature silicon jointing

compound externally round the end of the fitting

and internally round the end of the tube.

Enter the fitting into the tube using a slight

rotating movement to spread the jointing

compound uniformly until a penetration of 75mm

(3in) is achieved.

Damper Blade

Vacuum Test Point

Emitter Tube

FLOW

External bead of

jointing compound

Manifold

Note The silicon jointing compound remains

workable after application for only 5 minutes.

Secure the joint by drilling through the tube and

fitting and fix with three pop rivets at 12 o'clock,

4 o'clock and 8 o'clock positions. 4.8mm

(3/16in) diameter pop rivets are recommended.

2.2.17 Detailed Assembly Drawings

The

following

pages

diagrams of the VSO and VSXO range of

heaters.

Please note the heater type, length and

reference number from the delivery/advice note

before identifying the correct model drawing

Doc No. 700021 Page 14 of 20

Fitting

Internal bead of

jointing compound

show

the

exploded