Ambirad COBRA CB40 설치, 작동, 유지보수 및 서비스 매뉴얼 - 페이지 7

{카테고리_이름} Ambirad COBRA CB40에 대한 설치, 작동, 유지보수 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambirad COBRA CB40 19 페이지. Gas fired radiant tube heaters

페이지 인쇄

8 Installation of Cobra heater

Health & safety

A qualified installer is required to install

the appliance in accordance with the rules

in force, and should the need ever arise to

convert the appliance for use with other

gases.

Installation

There is no on site assembly required for

the COBRA heater.

Attach an appropriate hanging

attachment to each of the six hanging

brackets.

The heater can be installed with the

packaging in place to protect the

casing from damage during installation.

Raise the heater into the air and affix to

the chain previously located of 4mm

(minimum) gauge galvanised welded link

construction. Alternatively, 10mm

diameter mild steel drop rods can be used.

Figure 4 Mounting of Cobra heater

Wall mounting brackets must support the

heater at an angle of inclination between

30˚ and 45˚, and are available from the

manufacturer. The angle can be varied by

adjusting the drop rods or chain on each

bracket. The bracket positions are critical

and when suspended they should have

the same orientation i.e. all the same

angle.

Note When installing the heater at an

angle the combustion fan outlet should be

positioned so that it remains vertical.

It is recommended that sufficient

clearance from any fixed structure (e.g. a

wall) is given above the burner and behind

the burner fan compartment to allow

sufficient room for the service of the

heater. (See section 7 on clearance

distances).

Note As a part of the heaters annual

service all dust deposits on the top of the

reflector should be removed before the

start of each heating season.

I m p o r t a n t

The heater should slope downwards towards the

Return Bend by approx. 10mm for both

horizontal and wall mounted installations.