ACR Electronics Astwood AW1MF 기술 매뉴얼 - 페이지 7

{카테고리_이름} ACR Electronics Astwood AW1MF에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Electronics Astwood AW1MF 13 페이지. Multifuel stove

Instructions for use with wood

 Slide the top air control to the right and pull open the primary air fully.

 Lay firelighters or rolled up newspapers on the grate and add a small

amount of kindling wood to the top. Place 1 or 2 small logs on the top.

 Light the newspaper or firelighters using a long taper and push the

door to.

 When the fire is burning fiercely, after a couple of minutes add more

logs and close the door.

 When the fire has become established, close the primary air down.

 The burning rate can be altered by moving the top air slide.

 Care should be taken to ensure that the logs are not placed higher

than the log guard allows.

Instructions for use with smokeless fuel

 Slide the top air control to the right and open the primary air fully.

 Lay firelighters or rolled up newspapers on the grate and add a small

amount of kindling wood to the top.

smokeless fuel on top.

 Light the newspaper or firelighters using a long taper and push the

door to.

 When the fire is burning fiercely, after a couple of minutes add more

smokeless fuel and close the door.

 When the fire has become established, close the top air down.

 The burning rate can be altered by moving the primary air slide.

 Care should be taken to ensure that the firebox is not overfilled with

smokeless fuel – it should be no higher than the log guard.

Re-fueling

Always refuel onto a bed of hot embers.

Never overload the stove – it will work very well with two medium sized

logs.

Once you have added more fuel, leave the door slightly ajar for a few

moments afterwards to allow the initial volatiles in the fuel to burn. Once

the new fuel is established, close the door and control the burn rate as

above.

Occasionally fumes may be emitted into the room during the refueling

process.

Place a small quantity of