Ambit P.F. Series 사용 설명서 - 페이지 3

{카테고리_이름} Ambit P.F. Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambit P.F. Series 6 페이지. Fire hydrant/hosereel portable tester

RESETTING OF DIGITAL DISPLAY TOTALIZER (type 8150)

(i)

Press UP key to scroll to "total 1" display.

(ii)

Press and hold the RIGHT arrow key until the display shows "rst tot1".

The totalizer will flash for 8 seconds and then it will automatically reset to 00000000.

•

Press the ENTER key while the display is flashing to reset immediately.

•

While the total value is flashing, you can cancel the reset by pressing UP and DOWN

keys together.

•

Totalizer #1 will be displayed for 5 minutes after the reset, then the standard totalizer

•

Press the UP or DOWN key to scroll back to the standard display immediately.

10.

NO FLOW AND ELAPSED TIME DISPLAY

If the flow stops, the Flow Rate displays the number of hours since flow was last detected. This

display will alternate with the normal Totalized Value and standard "no FLo" display every five

seconds. Any movement of the rotor in the pipe will reset the ELAPSED TIME display.

Illustrated: No flow for 3 hours

If it is found, that after using the flow tester, that LPS or

a 0/1600 kPa gauge is required, the flow tester can easily

be converted when the unit is next sent to Ambit for

selection will return.

2 s

*************************************************************

calibration/service.

*************************************************************

8 s

May 2020, Rev 4

5 m

Page 3 of 6