FlisKits Thing-a-ma-Jig 조립 지침 매뉴얼 - 페이지 6
{카테고리_이름} FlisKits Thing-a-ma-Jig에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FlisKits Thing-a-ma-Jig 8 페이지. Flying model rocket
페이지 인쇄20.
You now need to draw a line at all 4 marks on your body
tube. Figure 20 shows you how you can use a " drawer
sill" to draw a straight line. Open a drawer and lay your
body tube just inside the drawer front (this is the " sill" ).
Use the top of the drawer front as a guide to draw your
straight line.
You can also use the vertical edge of a
door opening, which is called a " door sill" .
Figure 20
21.
Locate your completed Engine Mount from Step 7.
Referring to Figure 21, pass the Kevlar® Cord up through
the body tube, from the bottom, until the cord comes out of
the top of the body tube.
Figure 21
22.
Referring to Figure 22 apply a bead of glue about 1"
inside the bottom of the body tube. NOTE: If you get
some glue on the Kevlar® Cord, don' t worry, that is fine.
Once the glue is in place, QUICKLY push the Engine
Mount all the way into the Body Tube until the two tubes
are flush (even) with each other, as shown.
ADULTS may wish to help with this step.
? 2006,FlisKits, Inc., All rights reserved - Kevlar® is a registered trademark of Dupont
Figure 22
23.
Make a mark on the body tube, on the Launch Lug Line,
3" from the bottom of the tube as shown in Figure 23.
Figure 23
24.
Referring to Figure 24, glue your Launch Lug in place as
shown
. (Thing-a-ma-FACT: The Launch Lug is used to guide
the model along its first three feet of flight. This lug slides over a
three foot long " Launch Rod" (thin steal rod) that is on the launch
pad.)
Figure 24
Thing-a-ma-Jig Instruction Sheet: INS-SP015