AMC iMIX 63 사용자 설명서 - 페이지 6
{카테고리_이름} AMC iMIX 63에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AMC iMIX 63 16 페이지. Stereo mixing preamplifier
AMC iMIX 63에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지)
페이지 인쇄
Rear Panel
1. FUSE HOLDER
Use T315mA 250V fuse only. Contact
with qualified service if fuse blows up
constantly.
2. MAIN POWER CONNECTOR
The connector is used to connect
the AC 220V – 240V ~50Hz power to
preamplifier.
3. DC 24V CONECTOR
This connector is designed to power
up preamplifier when the main power
is unavailable. Use only 24V power
supply or batteries and take attention
to polarity during the wiring. If both, AC
and
DC
power
preamplifier will use main AC power.
4. MASTER OUT
This is balanced, stereo line level
output, XLR connectors.
5. MONO OUTPUT
This is line level, balanced output,
6.3mm TRS connector.
6. MONITOR OUTPUT
This is line level, balanced output,
6.3mm TRS connector. Signal in this
output is available when MONITOR
BUTTON is in the ON position. In this
output
only
signal
connectors (input 1 - 6 ) is available.
are
connected;
from
combo
7. REC OUTPUT
This is line level, unbalanced stereo
output, RCA connector. Signal in this
output is independent from master,
mono or monitor knobs. The signal
level in this output depends from input
volume controls only.
8. LINE INPUTS
This is line level, unbalanced stereo
RCA inputs.
9. MIC/LINE INPUTS
This is universal, balanced combo
inputs for XLR and 6.3mm connectors.
Gain of these inputs and phantom
power can be set by the switch located
near the connectors. These inputs are
suitable for microphone and line level
audio.
10. PRIORITY
Input 1 can set as priority input. To
set
priority,
please
potentiometer to the right until the
end. To deactivate priority turn to the
left until the end.
11. GAIN SELECTOR
Gain selector is designed to set the
gain of the combo inputs and turn on
+20V phantom power. When gain
selector switch is set in to the
"PHANTOM POWER" position, the input
gain
is
set
to
automatically.
turn
priority
microphone