AMC iMIX 63 사용자 설명서 - 페이지 8

{카테고리_이름} AMC iMIX 63에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AMC iMIX 63 14 페이지. Stereo mixing preamplifier
AMC iMIX 63에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

Operation

Rear panel operation

FUSE HOLDER

Use T315mA 250V fuse only. Contact with qualified service if fuse blows up

constantly.

MAIN POWER CONNECTOR

The connector is used to connect the AC 220V – 240V ~50Hz power to pream-

plifier.

DC 24V CONECTOR

This connector is designed to power up preamplifier when the main power is

unavailable. Use only 24V power supply or batteries and take attention to polar-

ity during the wiring. If both, AC and DC power are connected; preamplifier will

use main AC power.

MASTER OUT

This is balanced, stereo line level output, XLR connectors.

MONO OUTPUT

This is line level, balanced output, 6.3mm TRS connector.

MONITOR OUTPUT

This is line level, balanced output, 6.3mm TRS connector. Signal in this

output is available when MONITOR BUTTON is in the ON position. In this output

iMix 63 Stereo mixing preamplifier

USER MANUAL

only signal from combo

connectors (input 1 - 6 ) is available.

REC OUTPUT

This is line level, unbalanced stereo output, RCA connector. Signal in this output

is independent from master, mono or monitor knobs. The signal level in this

output depends from input volume controls only.

LINE INPUTS

This is line level, unbalanced stereo RCA inputs.

MIC/LINE INPUTS

This is universal, balanced combo inputs for XLR and 6.3mm connectors. Gain

of these inputs and phantom power can be set by the switch located near the

connectors. These inputs are suitable for microphone and line level audio.

PRIORITY

Input 1 can be set as priority input. To set priority, please turn priority potenti-

ometer to the right until the end. To deactivate priority turn to the left until the

end.

GAIN SELECTOR

Gain selector is designed to set the gain of the combo inputs and turn on +20V

phantom power. When gain selector switch is set in to the "PHANTOM POWER"

position, the input gain is set to microphone automatically.