AMC IF800/P 설치 매뉴얼 - 페이지 3

{카테고리_이름} AMC IF800/P에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AMC IF800/P 4 페이지. Bidirectional wireless infrared detector

english

test mode worKing: Each detection is notified by the LED activation for 1 second. After the first detection the sensor need

10/20 sec. for become operative. After this time the sensor will be operative.The return to the operative state is notified by a LED

with 3 fast blink. The test mode is automatically activated during the first power up, the duration is 10 alarm cycles. After the

counting, the sensor will go in stand by mode (no alarm, no led). For re set the test mode open and close the tamper switch, or go

in keypad and enabled tes mode.

normal worKing mode : With the two-way system, all sensors will be inhibited when the system is disarmed, therefore will

not report any violations in the field of action, avoiding unnecessary consumption.

When the system is disarmed the sensor sends only the normal life test signal, as required by EN50131 rules. When the system

is armed, the sensors of the partition selected will be operative, that will give alarm in their detection area. The time between

detection is 5''. For LED walk test, it is possible to disable for reduce consumption, if is active the time of alarm detection signal is

of half second.

installazione / installation

italiano

Utilizzando uno strumento sottile spingere il tastino tondo sul lato anteriore del sensore (vedi figura 1) e aprire la cover. Rimuovere

la scheda elettronica dal fondo della cover facendo leva sulla clips lato morsetti ,forare gli sfondabili che si desidera utilizzare per il

fissaggio, oppure utilizzare l'apposito snodo (opzionale). Altezza consigliata per il fissaggio 2m.

Per memorizzare il dispositivo sul ricevitore, inserire la batteria nell'apposito vano, seguendo la giusta polarità, dopodichè utilizzare

il tasto LEARN , oppure inserire il codide ID direttamente sul softaware di programmazione della centrale o nella tastiera di

programmazione. Per la configurazione fare riferimento al manuale della centrale.

english

By using a thin instrument, push the round button on the front of the detector (see Figure 1) and open the cover. Remove the elec-

tronic board from the bottom of the cover by acting on the terminal side clip. Perforate the knockouts you want to use for fixing,

or use the optional swivel bracket.

Note:The recommended height for fixing is 2m.

To program the device into the receiver, insert the battery in the proper space, following the right polarity, and then use the LEARN

Button to send the Learning Signal to the receiver, or insert the ID code in keypad menu or in programming software.

For set up follow the instructions in panel.

www.amcelettronica.com

IF800 IT-EN v1.0