AMCOL 3500-ETC 운영자 매뉴얼 - 페이지 5
{카테고리_이름} AMCOL 3500-ETC에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AMCOL 3500-ETC 12 페이지. Electronic timing controller
AMCOL 3500-ETC에 대해서도 마찬가지입니다: 기술 설명 (8 페이지)
페이지 인쇄3 Assembly and Installation
PRIOR TO GETTING STARTED
WARNING! AMCOL 3500-ETC systems are only designed to function with correctly
•
installed and grounded 3500E Powder Coating Systems. For installation instructions for
3500E Systems, see the AMCOL 3500E Electrostatic Powder Dispensing System Operator's
Manual.
WARNING! These systems operate using 110VAC and 24VDC. Do not touch any bare or
•
exposed wires or terminals without confirming the system is not powered.
WARNING! Wear safety glasses at all times.
•
WARNING! Unplug the system during any assembly, disassembly, and related repairs.
•
WARNING! To protect the electronics from dust and other particles in the air, tighten all
•
cable glands, and do not leave the enclosure door open during normal operation.
Installation
1. Review the system to see that no obvious damage has occurred in
shipment.
2. See that all components are included and appropriate for your piece of
equipment.
3. Ensure the system is located near a 110VAC outlet for power.
4. Mount the system controls in a well-protected area, which can be easily
accessed by operations and maintenance personnel.
5. Attach prewired solenoid cap to existing solenoid connection.
6. Attach prewired control cable to the "remote" socket (#11) on the EPG
SPRINT controller.
3500-ETC Operator's Manual
P a g e | 4