FloatPac RainPac 설치 매뉴얼 - 페이지 7

{카테고리_이름} FloatPac RainPac에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FloatPac RainPac 16 페이지. Under house and decking flexible rainwater harvesting bladder tanks

페이지 인쇄

NOTE: BEFORE COMPLETING INSTALLATION AND GLUING ALL PVC TOGETHER, COMPLETE A DRY RUN TO ENSURE EVERYTHING FITS BEFORE CEMENTING

BEGINS.

TRENCH SIZE REQUIRED: 200MM WIDE X 700MM LONG X 500MM DEEP

FITTINGS REQUIRED FROM FITTING KIT:

1 X 100MM BSP SOCKET

1 X 100MM MBSP – F SOCKET

1 X 100MM – 90MM ADAPTOR

1 X 90MM M + F 90 DEGREE ELBOW

1 X 90MM M + M 90 DEGREE ELBOW

1 X 90MM X 500MM (SUGGESTED) LENGTH STORMWATER PIPE

IMPORTANT!!! DO NOT USE THE INLET FITTING LOCKING NUT AS A TIGHTENING ATTACHMENT POINT DURING INSTALLTION.

THIS CAN POTENTIALLY LOOSEN THE LOCKING NUT AND WILL CAUSE THE FITTING TO LEAK.

ONCE THE FITTINGS HAVE BEEN ATTACHED AND THE BLADDER IS FOLDED BACK OVER (SO THE FITTINGS ARE UNDER THE BLADDER), PLEASE ENSURE THE

DUG TRENCH IS FULLY BACKFILLED AND PACKED WELL.

INLET SETUP

SEE DRAWING ON THE NEXT PAGE FOR SCHEMATIC DRAWING

P a g e

7 | 15