Flocorp GUARDIAN 1000 G1 사용 설명서 - 페이지 6

{카테고리_이름} Flocorp GUARDIAN 1000 G1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Flocorp GUARDIAN 1000 G1 20 페이지. Wireless monitoring system

INSTALLATION INTO A VENT LINE

The following tools are required to complete this procedure:

• Two Pipe Wrenches

• 2-inch Vent Kit consisting of either non-metallic or Stainless Steel material

• one 2-inch Tee

• one 2-inch 90 Elbow

• two 2-inch Close Nipple

1) Using the two pipe wrenches, remove the existing vent assembly from the top of the tank.

2) Assemble the Vent Kit items in the manner shown in Figure 2.

3) Install the existing vent assembly onto the 90 Elbow as shown in Figure 2.

4) Install the Differential Pressure Guardian onto the top of the Tee as shown in Figure 2.

POLY TANK PREPARATION

Please check the following before installation of the Guardian 1000:

• A 2 inch diameter threaded opening is required for the installation of a Guardian. If the tank does not have a threaded

opening available, a hole must be cut into the top of the tank. Refer to the procedure below for the installing a plastic bung kit.

• For Differential Pressure Guardian installations, verify if a mechanical agitation device exists within the tank, which could

damage the sensor.

• For Ultrasonic Guardian installations, verify no obstructions exist within the tank which could alter the ultrasonic readings.

(877) 356-5463

(p) 330-331-7331

(f) 330-331-7172

www.FLO-CORP.com

REVA 1116