Amcor Ad 140 사용 설명서 - 페이지 7

{카테고리_이름} Amcor Ad 140에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amcor Ad 140 13 페이지. Home dehumidifier

emPTyiNG The wATer TANk

When the water tank is full, the unit will switch off

automatically and beep 15 times, the LED [2] will light up.

- hold the top and bottom center of the tank with both hands

and pull it out gently.

- after having emptied the tank, gently push the tank back

into its place. The LED light will go off.

warning:

1. Do not remove the float from the water tank. The tank full sensor will no longer

be able to detect the water level correctly without the float and water may leak

from the water tank.

2. If the tank is dirty, wash it with cold or lukewarm water. Do not use detergent,

scouring pads, chemically treated dust cloths, gasoline, benzene, thinner, or

other solvents, as these can scratch and damage the tank and cause water

leakage.

3. When replacing the drainage tank, press the tank firmly into place with both

hands. If the tank is not positioned properly, the "TANK FULL" sensor will be

activated, and the dehumidifier will not operate.

For the continuous drainage please follow these points:

1. Switch off the unit and remove the plug from the electrical

outlet.

2. Remove the rubber stopper.

3. Connect a drain tube (10 mm inner diameter) on the

drainage port.

4. Place the other end in a drain. Make sure the tube is free

from twists and bends.

Note: The water tank must always be in place, even during continuous drainage.