Amcor HD220 사용 설명서 - 페이지 8

{카테고리_이름} Amcor HD220에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amcor HD220 13 페이지.

ENGLISH

See page 4, fig. 4.

When the water container is full the WATER FULL indicator light will illuminate and

the unit will automatically shut off. Wait a few minutes to allow the water

to finish darining into the water container.

To remove the water container, disconnect from the mains, pull the lower front panel

forward. Pull out and lift the water container by the handle and carry it away for

emptying.

Gently replace the container and close the lower front panel. When the tank is

properly inserted, both the hole and the float mechanism in the container will be

located directly beneath the drainage spout and the WATER FULL indicator light

will go out.

See page 4, fig. 2.

This unit can alternatively be used with a continuous drainage hose as follows:

• Remove the water container from the unit.

• Pull the funnel selector to the continuous drainage position A, as shown in fig. 2

(right). It should be pulled forward and clicked into position. This avoids any

leakage.

• Pull out the water stopper at the back of the unit (fig. 2, left) and insert a 6mm

diameter (1.5mm thick) hose over the spout.

• Place the other end of the hose in a drain, ensuring that it is not twisted, folded, or

otherwise likely to obstruct the water flow.

• The pipe must be positioned so that there is a gradual downward slope from the

connecting point to the drain.

• Ensure that the outlet of the drainage pipe is not under the water level of the drain.

• Replace the water container.

Note: In very cold weather conditions, precautions should be taken to prevent the

drainage pipe from freezing.

To return to water container use, push the funnel selector into position B (fig. 2, right)

and reinsert the water stopper (fig. 2, left).

Emptying the Water Container

Continuous Drainage Operation