Amcor SD12 사용 설명서 - 페이지 7

{카테고리_이름} Amcor SD12에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amcor SD12 9 페이지. Dehumidifier
Amcor SD12에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)

Precautions:

1. The dehumidifier will not work if the required humidity level is higher than the ambient level.

2. To protect the compressor from possible damage, wait 3 minutes before restarting the

dehumidifier after it has been turned off.

3. The operational temperature range is 5 – 35 °C.

4. When the dehumidifier is in operation, the discharged air should be hotter than the ambient

air.

5. If the dehumidifier does not start (the operation indicator [3] does not illuminate) or makes

intermediate stops, check the plug and power supply. If they are in a normal working

condition, wait 10 minutes and restart. If the unit does not start, contact your supplier for

service.

DRAINAGE

The extracted water can be collected in the water container or

drained continuously through a flexible hose (not supplied).

Use of the water container

When the drain outlet is blocked by the stopper, the extracted

water will run into the water container.

When the container is full, the compressor and the fan stop

operating and the container full indicator [4] illuminates.

• Slowly slide out the container to the side (1) or to the front

(2).

• Lift the container slightly by the built-in handle, then pull it

out.

• When, after emptying, the container is put back in place, the

container full light will go off.

Continuous drainage

1. Remove the stopper from the drain outlet.

2. Place a 11 mm inner diameter hose over the outlet. The

other end of the hose should (without bends) end in a lower

level drainage point.

3. Remove the water container (empty if necessary) and put

the stopper from beneath in the drain hole to the water

container. Put the water container back in place.

Note: in very cold conditions, precautions should be taken to prevent the drain hose from

freezing.